Single Instance - Install Official Builds

Relaunch Kiauh by entering this command:

./kiauh/kiauh.sh

Enter in 1) [Install] menu by typing 1 then Enter:

Install 1) [Klipper] by typing 1 then Enter.

Select 1) [Python 3.x] (recommended) by typing 1 then Enter.

Then enter the number of Klipper instance by typing 1 and Enter to confirm:

When it's done, install 2) [Moonraker] by typing 2 then Enter and confirm by typing Y.

When it's done, install 3) [Mainsail] by typing 3 then Enter and select no by typing n when asked to add the recommended macros.

When it's done, go back to main menu by typing B then Enter.

Exit Kiauh by typing Q then Enter.

Enter the following commands (one at a time) to install KlipperScreen:

git clone https://github.com/Guilouz/KlipperScreen-Flsun-Speeder-Pad.git
sudo mv /home/pi/KlipperScreen-Flsun-Speeder-Pad /home/pi/KlipperScreen
cd ~/KlipperScreen
./scripts/KlipperScreen-install.sh

Note: Installation may take several minutes.

When it's done, enter this commands (one at a time):

cd ~
ln -s /home/pi/gcode_files/USB-Disk /home/pi/printer_data/gcodes/USB-Disk
sudo reboot

Your Speeder Pad now running offical builds with 1 instance.

Now you should flash your printers motherboard, see Firmware